Digital Monitoring Products Inc PC0132 用户手册

Secure the keypad base to the wall ensuring that the wall tamper switch makes 

proper contact with the wall. Use the supplied screws in the mounting hole locations 

as shown in Figure 9.

Figure 10 shows the Model 373-500 plug-in DC power supply connector. The plug-in 

power supply provides a six foot cord. The cord may be lengthened, but should be 

located within 100 feet of the keypad using 22 AWG wire. For ease of connection, 

locate the keypad near a wall outlet.
In addition to powering the keypad, the power supply also charges the internal back-

up battery. 

Firmly grasp the wires near the base of the connector and 

hold the outside edges of the keypad housing. Connect the 

power supply to the J5 header on the 9800 Series Wireless 

Graphic Touchscreen Keypads.
Note: Do not remove the PCB from the keypad housing to 

install the power supply connector.
When the power supply connector is plugged into the keypad, 

the internal battery is automatically connected. The keypad 

can operate from battery only as long as the power supply 

connector is plugged into the keypad.

Figure 9: 12 Vdc Wiring

White – Connect Reader Data 1

Orange – Door Strike Normally Open

Gray – Door Strike Common

Violet – Door Strike Normally Closed

Black –  Ground 

Red – Keypad Power 

Green/White – Connect Reader Data 0

Black/White

 

Black

 

Surface and Backbox

Mounting Holes

To A/C

Power

Supply

Tamper

J5

Black

/White 

Stripe (+)

Black

 (-)

Figure 10: Installing 

the Wiring Harness