Rockwell Collins Inc. 8222210 用户手册
D r a f t 1 A - C I S C O C O N F I D E N T I A L
6-11
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
Chapter 6 Troubleshooting
Low Power Condition
Configuring the Access Point System Power Settings Using a Browser
You can also use your browser to set the access point System Power Settings.
Note
The access point web-browser interface is fully compatible with Microsoft Internet Explorer version 6.0
on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98, Windows 2000, and
Solaris platforms.
on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98, Windows 2000, and
Solaris platforms.
Note
When using the access point browser interface, you should disable your browser pop-up blocker.
shows the system power setting options and indicates the power status of the access point.
Figure 6-2
System Power Settings
Caution
If the access point receives power through PoE, the output current of the power sourcing equipment
(PSE) cannot exceed 400 mA per port. The power source must comply with IEEE802.3af or IEC60950
for limited power sources.
(PSE) cannot exceed 400 mA per port. The power source must comply with IEEE802.3af or IEC60950
for limited power sources.
power options.
Table 6-3
Access Point System Power Settings and Cisco Switch Commands
Power Source
Access Point System Power Settings
Cisco Switch
Power Command
Power Command
AC power module
Configuration changes are not required
power inline never
Cisco switch that supports
Intelligent Power Management
Intelligent Power Management
1
Power Settings:
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
power inline auto
Cisco switch that does not
support Intelligent Power
Management
support Intelligent Power
Management
1
Power Settings:
Pre-standard Compatibility (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
power inline auto