Sony Corporation HWSAV10T 用户手册

You can operate the A/V equipment connected to the transmitter using the remote control in
another room.

PLAY

PLAY

Set the IR Blaster by the following procedure.

Do not remove the opposite face of the double sided seal yet. You can also use a
store-bought double sided seal.

Do not connect the other of supplied IR Blaster.

To locate the infrared receiver, see the instruction manual for the connected A/V
equipment. Make sure to place the IR Blaster just above the infrared receiver.

Point and operate the remote control of A/V equipment at the receiver’s infrared receiver,
and check the performance of the connected A/V equipment correctly.

After performing the operation test on the connected A/V equipment, remove the opposite
face of the double sided seal, and then fix the IR Blaster in the installation in step 3.

• Some A/V equipment may not operate correctly, depending on the installation location. Install the IR

Blaster and A/V equipment’s infrared receiver as close as possible.

• If other A/V equipment is nearby the transmitter, accidental wrong operation of this A/V equipment may

occur due to the location of the IR Blaster. In this case, change the installation location of the IR Blaster.

• If you place the transmitter too close to the receiver, the signal may be looped from the receiver back to

the transmitter. In this case, place the receiver further apart from the transmitter.