Honeywell International Inc. WFSRM 用户手册
62
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000NF-E:C 5/8/2015
LED Indicators
LED Pattern
Condition
Action Required
Legend
Number of blinks
LED color
Interval between blink patterns
Duration of LED state
Indicates value is approximate
LED color
Interval between blink patterns
Duration of LED state
Indicates value is approximate
Two blinks in this pattern
First blink is green. Second is yellow
7 seconds between blink patterns
7 seconds between blink patterns
Will transition to next state after
approximately 20 minutes
approximately 20 minutes
Example:
All units are in seconds. Minute is indicated by “M”.
le
dd
ev
2
.wmf
7
20
M
Device LED Patterns (Continued)
Battery Check: all
batteries present
batteries present
Searching for mesh
(in rescue mode)
(in rescue mode)
Profile
modification
modification
1st mesh
restructuring
restructuring
Generic device trouble
(dual address, low
battery, etc.) or
untested walk test
(dual address, low
battery, etc.) or
untested walk test
Searching for mesh
(in formation mode)
(in formation mode)
Minimum of 6 months battery
life remaining.
life remaining.
Device has a profile and
can be set as a distributor
or have profile removed.
can be set as a distributor
or have profile removed.
Mesh is formed and
initializing.
initializing.
Device is in the mesh and in
a trouble condition or the
panel is in walk test and this
device is not tested.
a trouble condition or the
panel is in walk test and this
device is not tested.
Profile is assigned and device
is searching for the mesh.
is searching for the mesh.
Profile is assigned and device
is searching for the mesh.
is searching for the mesh.
Tamper entry
Device has just been
tampered.
tampered.
Ensure the mesh is in rescue
mode or wait for timeout to search
mesh in formation mode.
mode or wait for timeout to search
mesh in formation mode.
Discovered mesh
Device discovered the
mesh.
mesh.
60
Solid
2.5
Toggle SLC address dials to
respective pattern to enter
desired mode.
respective pattern to enter
desired mode.
90
3
Ensure the mesh is in formation
mode.
mode.
25
7
5
M
Refer to the FACP to identify the
trouble and possible resolution.
The NFS2-640/NFS-320 does not
support trouble indication.
trouble and possible resolution.
The NFS2-640/NFS-320 does not
support trouble indication.
14
4
Ensure detector is seated in the base
and the module has a faceplate.
and the module has a faceplate.
Solid
6
5
Solid
Waiting for a profile
Searching for a profile
Pending site survey
Alarm state
Battery Check:
weak
weak
Device is in factory default
mode.
mode.
Device is in factory default
mode and requesting a profile
from a distributor or gateway.
mode and requesting a profile
from a distributor or gateway.
Device is in factory default
mode and is ready to enter
site survey mode.
mode and is ready to enter
site survey mode.
Less than 6 months
battery life left or not all 4
batteries are present.
battery life left or not all 4
batteries are present.
Device is functioning as
normal and has been
activated.
normal and has been
activated.
Use SWIFT Tools to assign a
profile or activate magnetic sensor
to search for a profile.
profile or activate magnetic sensor
to search for a profile.
Ensure all 4 batteries are present
or replace the batteries.
or replace the batteries.
Clear the tamper condition within 1
minute to enter site survey mode.
minute to enter site survey mode.
10
5
Solid
2.5
3
0.5
1
M