JAPAN REMOTE CONTROL CO. LTD. L25-N4580 用户手册
6-1
Post-Flight Inspection and Cleaning
In preparation for the next flight, inspect the heli-
copter and make sure each area is free of prob-
lems. In addition, enter the results in the flight
inspection log.
copter and make sure each area is free of prob-
lems. In addition, enter the results in the flight
inspection log.
Fuel Inspection
Inspect for fuel leakage.
Before performing this inspection, turn OFF both
the main switch for the helicopter and the power
switch for the transmitter.
Before performing this inspection, turn OFF both
the main switch for the helicopter and the power
switch for the transmitter.
For details, see page 4-19.
If you discover any fuel leakage, request a repair by
your dealer before the next flight.
your dealer before the next flight.
Post-flight Inspection
● To prevent injury, make sure the engine is
stopped before performing an inspection.
● The helicopter is very hot immediately
after a flight. To prevent burns, allow the
temperature of the helicopter to lower suf-
ficiently before performing an inspection.
temperature of the helicopter to lower suf-
ficiently before performing an inspection.
WARNING
Inspection Point
Inspection Items
Flight
Pre Post
Transmitter
• Battery Level
• Operation
• Antenna installation
• Operation
• Antenna installation
1 Fuel
• Level
• Leakage
• Leakage
2 Coolant, oil
• Level
• Leakage
• Leakage
3 Rotor blades
• Dirtiness, damage
• Movement
• Movement
4 Air cleaner
• Dirtiness
5
Servo, linkage
(rudder, throttle)
(rudder, throttle)
• Operation
• Wobble
• Wobble
6 Self monitor
• States of lighting
Radio signal
distance test
distance test
• Radio signal reach
7 Tail rotor drive belt
• Tension
• Abnormal noise
• Wear, damage
• Refuel
• Abnormal noise
• Wear, damage
• Refuel
GPS system
• States of lighting
8 Antenna
• Installation state
• Rust
• Rust
Fuel leakage could lead to a fire.
WARNING
RMAX.book Page 1 Tuesday, January 17, 2012 3:06 PM