Nautel Maine Inc VS300 用户手册
VS300 Operations and Maintenance Manual
Operating the transmitter
Issue 0.1 2011-03-11
Page 2-83
Configuring RF drive source
From the front panel UI, you can configure the source of the transmitter’s RF drive (internal or
external). To view the
external). To view the
RF Drive Source
screen, select
System Settings -> RF Drive Source
from the
Main Menu
(see
).
Figure 2.76: RF Drive Source Menu
Use the up and down buttons to toggle between
Internal VS Exciter
and
External Exciter
. Press the
accept (checkmark) button to save the change. Press cancel (
X
) to discard changes and return to the
previous menu. If you select
External Exciter
, proceed to
“Connecting an external analog exciter”
for connection details.
Connecting an external analog exciter
Configure the transmitter for an external analog exciter as follows:
1. Change the RF drive source.
2. Turn off the transmitter, remove it from its host cabinet and place it on a suitable work
surface.
3. Remove the top cover.
4. Disconnect W5P1 from A1J1 and connect it to J4 on the inside of the box.
5. Re-install the top cover and re-insert the transmitter in its host cabinet.
6. With a user-supplied CAT5 cable, connect a wire between A1J1-7 (RF mute) and the the RF
mute input on the external exciter. Note: The RF mute signal from the VS300 is active low
and will not function if the external exciter is not configured in the same way.
and will not function if the external exciter is not configured in the same way.
Note:
Configuration of the RF drive source is only available using the front panel display.