Andrew Wireless Innovations Group RPT-EAC2100 用户手册
Quick Start Checklist
AMPS EAC-
2100
Manual: (Draft, 02/01)
Page
Programming Initial Parameters
(See Sections 4, 5, and 6)
1.
Type SSS <CR>. (Nothing should show DISABLED. If anything shows
disabled, refer to Appendix A, Troubleshooting Guide.)
disabled, refer to Appendix A, Troubleshooting Guide.)
2.
Type ALA <CR>. (There should be no alarms. If there are any OUT OF
SERVICE or memory alarms, refer to Appendix A.)
SERVICE or memory alarms, refer to Appendix A.)
3.
Type SET <CR> and go into submenu C, System Parameters.
4.
Enter submenu A and program the site ID.
5.
Enter submenu B and program the donor and boosted DCCH channels.
Decide how the DCCH control channel is to act when all channels are busy.
Decide how the DCCH control channel is to act when all channels are busy.
6.
Enter submenu C and program the boosted DTC RF channel numbers for
channels 2–4.
channels 2–4.
7.
Program the donor DTC RF channels into list.
8.
Enter the Modem Control submenu D and program the modem mobile MIN
that has been assigned. Calls made to and from this number will not be
transferred to the booster, but will be trapped-out and handled directly by the
donor. Also set the modem mobile power step to the desired level.
that has been assigned. Calls made to and from this number will not be
transferred to the booster, but will be trapped-out and handled directly by the
donor. Also set the modem mobile power step to the desired level.
9.
Use <CTRL> X to exit the SET menu completely. Press <CR> at the
question prompt.
question prompt.
Continued . . .