Andrew Wireless Innovations Group RPT-EAC2100 用户手册
HEALTH AND SAFETY WARNINGS
Installer Warning:
Any over-the-air radiated use of this product is intended to be used with either
Roof Top (Building-mount) or Pole Mounted (Non-building-mount) Antennas.
Roof Top (Building-mount) or Pole Mounted (Non-building-mount) Antennas.
Antenna installation must conform within the following guidelines to meet FCC
RF exposure limits. Otherwise a environmental evaluation is required if:
RF exposure limits. Otherwise a environmental evaluation is required if:
Narrowband PCS (subpart D): Non-building-mounted antennas: height above ground
level to lowest point of antenna < 10m Radio (Part 24) and total power of all channels >
1000 W ERP (1640 W EIRP).
level to lowest point of antenna < 10m Radio (Part 24) and total power of all channels >
1000 W ERP (1640 W EIRP).
Building-mounted antennas: Total power of all channels > 1000 W ERP (1640 W EIRP).
Cellular Radiotelephone Service (Part 22, subpart H): Non-building-mounted antennas:
height above ground level to lowest point of antenna < 10m Radio (Part 22) and total
power of all channels > 1000 W ERP (1640 W EIRP).
height above ground level to lowest point of antenna < 10m Radio (Part 22) and total
power of all channels > 1000 W ERP (1640 W EIRP).
Building-mounted antennas: Total power of all channels > 1000 W ERP (1640 W EIRP).
For clarification, please refer to FCC rules, 47 CFR ch. I, part 1.1307
F
Note:
The electrical installation has to be performed in accordance with the safety
regulations of the local authorities. Due to safety reasons, the electrical installation
must be performed by qualified personnel. Subsequent installation, commissioning
and maintenance activities that require the unit to be powered with the cover open
shall only be carried out by suitably qualified personnel.
regulations of the local authorities. Due to safety reasons, the electrical installation
must be performed by qualified personnel. Subsequent installation, commissioning
and maintenance activities that require the unit to be powered with the cover open
shall only be carried out by suitably qualified personnel.
F
Note:
The grounding of the Unit has to be performed in accordance with local electrical
codes. A grounding bolt is provided at the bottom of the cabinet in order to connect
the earth bonding cable.
codes. A grounding bolt is provided at the bottom of the cabinet in order to connect
the earth bonding cable.
F
Note:
The Unit weighs 210 lb (95 kg). Make sure that a suitable mounting surface is used
if it is to be wall-mounted, or an adequate floor surface to support the weight is
available if it is to be pedestal-mounted. Also, make sure that adequate lifting tools
are available for placing the unit either on its wall bracket or on the pedestal.
if it is to be wall-mounted, or an adequate floor surface to support the weight is
available if it is to be pedestal-mounted. Also, make sure that adequate lifting tools
are available for placing the unit either on its wall bracket or on the pedestal.