Hammer Fiber Optics Investments LTD. AIRTC31 用户手册
2.6.1 F-Connector installing instruction
To avoid water intrusion to the AIR transceiver a self-vulcanization tape must be applied to
the outdoor connector as shown in the picture below. It is necessary to apply the tape at the
base of the trans-connector and move up in at least two wraps at long of the whole trans-
connector, connector and 1 to 2 cm over the cable. The tape should be wrapped with a low
pulling force. The tape must not be torn in the process of wrapping. If the tape is applied
with to high pulling force, the tape can break under environmental influences. On every
wrap the tape must cover at least half of the first applied wrap along the whole length of the
trans-connector, connector and 1 to 2 cm of cable.
the outdoor connector as shown in the picture below. It is necessary to apply the tape at the
base of the trans-connector and move up in at least two wraps at long of the whole trans-
connector, connector and 1 to 2 cm over the cable. The tape should be wrapped with a low
pulling force. The tape must not be torn in the process of wrapping. If the tape is applied
with to high pulling force, the tape can break under environmental influences. On every
wrap the tape must cover at least half of the first applied wrap along the whole length of the
trans-connector, connector and 1 to 2 cm of cable.
Figure 10: F-connector seal