OSD Audio.Inc JAPC 用户手册
4
Congratulations and thank you for purchasing the Pro-Connect Sound Stage Table-Top Surround Sound System. The
Pro-Connect Sound Stage greatly enhances the sound quality of today’s flat screen LED, LCD and Plasma TVs without having
to add a lot of speakers. A single speaker system that requires very little space, the SOUND STAGE can be installed below or
in front of a high definition TV or inside a cabinet. You’ll enjoy simulated surround sound from a single, space- saving cabinet
with deep, enveloping bass without bulky speakers or amps. The Pro-Connect SOUND STAGE easily connects to inputs on
to add a lot of speakers. A single speaker system that requires very little space, the SOUND STAGE can be installed below or
in front of a high definition TV or inside a cabinet. You’ll enjoy simulated surround sound from a single, space- saving cabinet
with deep, enveloping bass without bulky speakers or amps. The Pro-Connect SOUND STAGE easily connects to inputs on
today’s flat panel TVs and digital music players and even syncs to almost any Bluetooth audio device.
SOLID BLUE – ON – Pro-Connect SOUND STAGE is ON.
SINGLE BLUE FLASH - Confirms receiving an IR command from the Pro-Connect Sound Stage Remote for changes to
Treble/Bass, EQ Reset, Simulated Surround (SR), single Volume UP/DOWN command, initiating output of the Bluetooth
Connection Code.
Treble/Bass, EQ Reset, Simulated Surround (SR), single Volume UP/DOWN command, initiating output of the Bluetooth
Connection Code.
RAPID BLUE FLASH - Confirms receiving a continuous IR stream from the SOUND STAGE Remote for ramping volume
UP/DOWN. Rapid blue flash also indicates the SOUND STAGE is in Bluetooth pairing mode.
UP/DOWN. Rapid blue flash also indicates the SOUND STAGE is in Bluetooth pairing mode.
SLOW BLUE FLASH - Audio Mute. Audio signal to the speakers is turned OFF.
TWO BLUE FLASHES; DELAY - Bluetooth input is selected and no Bluetooth device is connected or it is out of range.
2. IR SENSOR - (Behind front panel lens.) The IR Sensor ‘sees’ the IR control commands output from the SOUND STAGE IR
Remote Control when buttons are pressed on the remote for armchair control of the SOUND STAGE. This sensor must be
unobstructed for direct line-of-sight to the remote, or the remote will not be able to control the SOUND STAGE.
Remote Control when buttons are pressed on the remote for armchair control of the SOUND STAGE. This sensor must be
unobstructed for direct line-of-sight to the remote, or the remote will not be able to control the SOUND STAGE.
3. FRONT AND REAR PANEL BASS PORTS -Two pairs of tuned openings in the SOUND STAGE cabinet allow air to
‘release’ from the cabinet and enhance low frequency audio. Allow at least 3 inches of clearance to a back wall to allow air to
move freely from the ports for full bass extension.
‘release’ from the cabinet and enhance low frequency audio. Allow at least 3 inches of clearance to a back wall to allow air to
move freely from the ports for full bass extension.
Pro-Connect
SOUND STAGE
FRONT PANEL
INTRODUCTION
Pro-Connect
SOUND STAGE
REAR PANEL
1 2
3
3
Back Panel Connection Plate
1. STATUS LED - (Behind front panel lens.) One multi-color LED. This LED will illuminate red/blue and flash in different modes
to indicate changes in the SOUND STAGE operational status. SOLID RED - OFF (Standby). Power cord is connected and AC
switch is turned ON, but the SOUND STAGE is OFF.
to indicate changes in the SOUND STAGE operational status. SOLID RED - OFF (Standby). Power cord is connected and AC
switch is turned ON, but the SOUND STAGE is OFF.