Guangzhou Amason Electronics Co. Ltd. AMASON 用户手册
34
35
Trobleshooting
Problem
Cause/Action
There is noise when turn on/off the
power.
This is normal
After turn on the power, no sound is
produced when press the keys.
Please confirm the connection to power is good
The note and its timber are of a little
differences under the same patch. This is normal
When use the sustaining function,
some patches are long while others
are short.
This is normal
The volume is too low.
Please turn up the the sound by using the volume switch buttom
Pitch from speakers does not match
the key played
Please check if the double keyboard mode or transposition
mode is on
Nose comes from speakers when
near sell phones
This is normal, caused by interferance from mobile signals
When use the mobile phone, there
is some noises.
Moblie phone could bring in disturbance. To avoid the
noise, turn off the moblie or keep away from
the piano.
noise, turn off the moblie or keep away from
the piano.
When play the piano, the pitch
is not
in accordance with the keyboard.
You may activate the SPLIT mode function.
Please turn off it.
Please turn off it.
Pitches can not be changed
when playing the piano, and
the pitch is not in accordance
with the keyboard.
You may activate the SPLIT mode function and
set the split point to the highest level. Turn off the SPLIT
mode function
and set the split point to the original.
set the split point to the highest level. Turn off the SPLIT
mode function
and set the split point to the original.
Distortion or intermittent for
the demo songs.
Long time playing leads to high temperature of the amplifier,
so self-
protection system of the circuit board will startup. Turn
down the volume or
turn off the power for a while then it will return to
normal.
so self-
protection system of the circuit board will startup. Turn
down the volume or
turn off the power for a while then it will return to
normal.
Two sounds appear at the
same time when playing the
piano
You may activate the dual mode function. Turn off it.
Dynamics is not as before
There are four dynamics, including weak, standard, strong and
off. You may select different dynamics. Select the dynamics
again as per your needs.
off. You may select different dynamics. Select the dynamics
again as per your needs.