Elecsys International Corporation 02008410 用户手册

Elecsys Confidential

For Internal Use Only

Rev A – USA / Canada

23 August 2018

Elecsys P/N

Type

Gain (dBi)

48-0003-36
48-0003-37

SMT PIFA

RP-SMA Dipole

1.5
2.3

48-0003-38

RP-SMA Omni

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:

  Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.
  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  Consult the dealer or an experienced radio/TV technician for help.

(§ 15.105(b))

INDUSTRY CANADA

INDUSTRY CANADA REGULATORY

REGULATORY

REGULATORY NOTICES

NOTICES

NOTICES::::

IC: 12222A-02008410
This device complies with Industry Canada’s license-exempt RSS standard(s). Operation is subject to the following
two conditions:
(1)  This device may not cause interference; and
(2)  This device must accept any interference, including interference that may cause undesired operation of the

device.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.

This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below with
the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with this module.