Invenco Group Ltd G6OPT 用户手册
DCV-00001 Rev 05 S2 G6 OPT Installation Guide
Page 18
4.5.4 Main Power Supply Wiring
The other end of the low-voltage DC Cable is connected into the AC-DC power supply as
below:
below:
Note: If retrofitting in place of a G5 OPT, the power supply may be able to be re-used. In this
case the old 24V DC cable that powered the G5 OPT must be disconnected and replaced
with the new cable for the G6 OPT.
WARNING
– Once all the wiring to the power supply terminals has been completed,
install the terminal cover to prevent accidental contact with the live mains connections.
4.5.5 Wiring Completion
When all the cables have been installed, use cable ties to provide strain relief. The rear of the
G6 OPT has two plastic loops close to the connectors that are intended to assist with this.
Also ensure that all cables are tidy and cannot become snagged or pinched when the door of
the cabinet is opened and closed.
WARNING
G6 OPT has two plastic loops close to the connectors that are intended to assist with this.
Also ensure that all cables are tidy and cannot become snagged or pinched when the door of
the cabinet is opened and closed.
WARNING
– Local regulations may also require that the installation is electrically
tested and certified BEFORE switch-on.
!
!