CILICO ELECTRONICS CO. LTD CT10 用户手册

 

10

If you want to exit the setting mode without saving any changes, you must have the 

scanner read the "Exit without Save" barcode. 

Just like reading the "Enter Setup" barcode, the scanner will respond with three beeps 

(tone ascending from low to high) after reading the barcode. 

 

 

 

 

 

 

 

"Restore Factory Defaults" is a special barcode. The CT10 Barcode Scanner will respond 

with a short beep (high tone) after reading this barcode. At this time, the scanner system 

could restore factory defaults, and no need to read "Exit with Save" barcode again. The 

Scanner defaults enable HID, PIN defaults 10010.   

 

 

 

 

 

 

 

Note: 

Most of setting mode have restore factory defaults selection. The factory default 

value for each setting is indicated by an asterisk "*". 

You could use this barcode at the following status: 

1、The scanner can not work. For example, it can not read barcodes.     

2、You forget the settings you did to the scanner before, and you don't want to be affected 

by the settings when you use the scanner. 

3、After using a function which is not be used usually in the scanner. 

 

If you want to know the software version of CT10, should read the ‘Enter Setup’ and 

‘Output Software Version’ barcode:   

 

 

Restore Factory 

Exit without Save