Prentke Romich Company ACN800PRC 用户手册
Accent 800 Hardware Manual
Page 20
Attaching or Removing a TouchGuide
Attaching the TouchGuide
1. Attach the device frame, if you have not already done so. See “Attaching the Device Frame” on page 18.
2. Align the TouchGuide so that the two squares
at the top are positioned at the upper right
corner of the display.
3. With the bottom tabs in place, lift upward
with your fingers to bend the top right corner
of the TouchGuide slightly and insert the tab
into the top right slot of the frame.
Then insert the bottom tabs of the TouchGuide
into the slots at the bottom edge of the frame.
Note: The TouchGuide plastic is stiff and may
require some effort to bend.
4. Insert the left tab into the top left slot of the frame using the same method as in step 3. The
TouchGuide is now ready to use.
Removing the TouchGuide
Note: Avoid pulling on the thin pieces of plastic.
1. Grasp the thicker plastic above the first row of
1. Grasp the thicker plastic above the first row of
keyholes.
2. Pull out and down on the TouchGuide until the
upper tabs pop out.
Grasp the thicker plastic
Position squares
in upper right
Insert bottom
tab into slot
PRELIMINARY