Extron Electronics EXTWAP100AC 用户手册
Mounting to a Solid Ceiling or Wall
What sized drill?
How far apart are
the holes?
How far apart are
the holes?
To mount the WAP 100AC to a solid ceiling or wall, Extron provides mounting
bracket (figure 17,
2
) and a wall mounting hardware kit that includes:
•
Two wall plugs (
1
)
•
Two P3.5x32 screws (
3
)
•
Two P2.6x12 screws (
4
)
Wall or
Solid Ceiling
1
2
3
4
5
Turn the WAP 100AC about
90° clockwise to lock it in position.
Figure 37.
Mounting the WAP 100AC to a Solid Ceiling or Wall
To mount the unit, follow these instructions:
1.
Drill two holes 3 inches (7.62 cm) apart.
2.
Screw in the wall plugs.
3.
Attach the mounting bracket, using the P3.5x32 screws.
4.
Insert the P2.6x12 screws into the mounting holes on the top of the WAP 100AC
(
(
5
). Leave enough of the screws exposed to insert them into the mounting bracket.
If you need extra space between the WAP 100AC and the mounting bracket, use the
spacers and long screws from the T-rail mounting kit (see Mounting to a Dropped Ceiling
on the following page).
spacers and long screws from the T-rail mounting kit (see Mounting to a Dropped Ceiling
on the following page).
5.
Connect the cables. The WAP 100AC can use a 12 VDC desktop power supply or a
PoE injector. Extron recommends using PoE.
PoE injector. Extron recommends using PoE.
ATTENTION:
•
Do not connect either power supply before reading the Attention notifications
on
on
page 6
or
page 7
.
•
Ne branchez pas de sources d’alimentation externes avant d’avoir lu les mises
en garde dans la section « Power Supply » sur
en garde dans la section « Power Supply » sur
page 6
ou
page 7
.
•
Disconnect power from either power supply before making any connections.
•
Débranchez de sources d’alimentation externes avant d’effectuer n’importe
quelles connexions.
quelles connexions.
•
If you are using PoE, connect the LAN cable only (figure 2,
A
).
•
If you are using a 12 VDC desktop power supply, connect the power supply
cable (figure 2,
B
).
6.
Insert the heads of the P2.6*12 screws (see step 4) into the holes in the mounting bracket.
7.
Turn the WAP 100AC about 90° clockwise to lock it into place.
WAP 100AC • Mounting
40