Extron Electronics EXTWAP100AC 用户手册
8.
Power on the PoE injector or 12 VDC power supply.
•
The power LED lights (orange).
•
The WLAN LEDs light (blue for 2.4G and green for 5G)
•
The LAN connection LED lights (blue)
You are now ready to configure the WAP 100AC (see Internal Web Pages on page 9).
Mounting to a Dropped Ceiling
To mount the WAP 100AC to a dropped ceiling, Extron provides a mounting hardware kit
that includes:
that includes:
•
Two 9/16 inch (1.43 cm) T-rail connectors (figure 18,
1
)
•
Two 15/16 inch (2.38 cm) T-rail connectors (
2
)
•
Two spacers (
3
)
•
Two P2.6*10 screws (
4
)
•
Two P2.6*25 screws (
5
)
Figure 38.
Preparing the WAP 100AC to Mount in a Dropped Ceiling
To mount the unit, follow these instructions:
1.
Decide whether you need the 9/16 inch or 15/16 inch T-rail connectors and whether
you need to use the spacers to accommodate ceiling tiles.
you need to use the spacers to accommodate ceiling tiles.
If you do not need the spacer, use the shorter (P2.6*10) screws. If you require the
spacers, use the longer (P2.6*25) screws.
spacers, use the longer (P2.6*25) screws.
2.
Connect the cables. The WAP 100AC can use a 12 VDC desktop power supply or a
PoE injector. Extron recommends using PoE.
PoE injector. Extron recommends using PoE.
ATTENTION:
•
Do not connect either power supply before reading the Attention notifications
on
on
page 6
or
page 7
.
•
Ne branchez pas de sources d’alimentation externes avant d’avoir lu les mises
en garde dans la section « Power Supply » sur
en garde dans la section « Power Supply » sur
page 6
ou
page 7
.
•
Disconnect power from either power supply before making any connections.
•
Débranchez de sources d’alimentation externes avant d’effectuer n’importe
quelles connexions.
quelles connexions.
•
•
If you are using PoE, connect the LAN cable only (figure 2,
A
, on page 4).
If you are using a 12 VDC desktop power supply, connect the power supply
cable (figure 2,
B
).
Figure 39.
Attaching the WAP 100AC to T-Rail
3.
Align the T-rail connectors with the T-rail and press the unit until the connectors snap
into place.
into place.
4.
Power on the PoE injector or 12 VDC power supply.
•
The power LED lights (orange).
•
The WLAN LEDs light (blue for 2.4G and green for 5G)
•
The LAN connection LED lights (blue)
You are now ready to configure the WAP 100AC (see Internal Web Pages on page 9).
Kensington Security Lock
For added security, once the installation is complete, attach a Kensington Security Lock
(not provided) to the metal-reinforced slot on the top of the unit (see figure 2,
E
).
Follow the instructions that are provided by the manufacturer to install the lock.
WAP 100AC • Mounting
41