Intel Z520PT CH80566EE014DT 数据表
产品代码
CH80566EE014DT
68
Datasheet
5.1
Thermal Specifications
The processor incorporates three methods of monitoring die temperature—Digital
Thermal Sensor, Intel Thermal Monitor, and the Thermal Diode. The Intel Thermal
5.1.2) must be used to determine when the maximum
specified processor junction temperature has been reached.
5.1.1
Thermal Diode
The processor incorporates an on-die PNP transistor whose base emitter junction is
used as a thermal “diode”, with its collector shorted to ground. The thermal diode can
be read by an off-die analog/digital converter (a thermal sensor) located on the
motherboard or a stand-alone measurement kit. The thermal diode may be used to
monitor the die temperature of the processor for thermal management or
instrumentation purposes but is not a reliable indication that the maximum operating
temperature of the processor has been reached. When using the thermal diode, a
temperature offset value must be read from a processor MSR and applied. See
5.1.2 for more details. See Section
5.1.3 for thermal diode usage
recommendation when the PROCHOT# signal is not asserted.
The reading of the external thermal sensor (on the motherboard) connected to the
processor thermal diode signals will not necessarily reflect the temperature of the
hottest location on the die. This is due to inaccuracies in the external thermal sensor,
on-die temperature gradients between the location of the thermal diode and the
hottest location on the die, and time based variations in the die temperature
measurement. Time based variations can occur when the sampling rate of the thermal
diode (by the thermal sensor) is slower than the rate at which the T
J
temperature can
change.
Offset between the thermal diode based temperature reading and the Intel Thermal
Monitor reading may be characterized using the Intel Thermal Monitor’s Automatic
mode activation of the thermal control circuit. This temperature offset must be taken
into account when using the processor thermal diode to implement power
management events. This offset is different than the diode T
OFFSET
value programmed
into the processor Model Specific Register (MSR).
model parameters shown in Table 19 provide more accurate temperature
measurements when the diode ideality factor is closer to the maximum or minimum
limits. Contact your external sensor supplier for their recommendation. The thermal
diode is separate from the Thermal Monitor’s thermal sensor and cannot be used to
predict the behavior of the Thermal Monitor.