Troy-Bilt HYDROSTATIC LAWN TRACTOR - HORSE 769-06304 用户手册

The parking brake pedal is located on the left side running board 

of the lawn tractor. It is used to both set the parking brake and to 

stop the lawn tractor in sudden situations.
The parking brake lever is located on the left side of the tractor’s 

dash panel. To set the parking brake, fully depress the parking 

brake pedal. Move the parking brake lever all the way down and 

into the parking brake position and then release the brake pedal 

to allow the parking brake to engage.
To release the parking brake, depress the brake pedal and the 

parking brake lever will automatically move out of the parking 

brake position.
In an sudden situation, fully depress the brake pedal to bring the 

tractor to a stop and then immediately move the speed control 

lever to the “N” neutral position

Do not use the parking brake pedal to control 

the ground speed of the lawn tractor. Doing so will result in 

premature wear of drive belt. Always use the Speed Control Lever 

to control the ground speed of the lawn tractor and to stop the 

tractor under normal circumstances.

The parking brake pedal must be depressed to start the 

engine. The parking brake must also be set if the operator leaves 

the seat with the engine running or the engine will automatically 

shut off. Refer to Safety Interlock Switches on page 14.

Found on the tractor’s right fender, the PTO (blade engage) lever 

is used to engage power to the cutting deck or other (separately 

available) attachments. To operate, move the lever all the way 

forward. Moving the lever all the way rearward into the PTO OFF 

position disengages power to the cutting deck/ attachment. 
NOTE: The PTO (blade engage) lever must be in the disengaged 

(PTO OFF) position when starting the engine.