Konica Minolta bizhub C652DS 用户手册
bizhub C652/C652DS/C552/C552DS/C452
5-12
5.1
Basic
5
5.1.6
Post Inserter
When the Post Inserter PI-505 is installed on the Finisher FS-526, you can manually operate the Finisher
FS-526 using the post inserter control panel.
FS-526 using the post inserter control panel.
Reference
-
Only the lower tray can be used as the output tray. The upper tray is not available.
Keys on control panel
Position Setting
Configure desired staple or hole-punch positions.
Select Auto, and the machine automatically judges the staple or punch posi-
tions for the paper relative to the original direction loaded.
•
tions for the paper relative to the original direction loaded.
•
A staple or hole-punch position is set along the long side of the paper if the
original length is 11-11/16 inch (297 mm) or less.
original length is 11-11/16 inch (297 mm) or less.
•
Staple or hole-punch positions are set along the short side of the paper if
the original length is more than 11-11/16 inch (297 mm).
the original length is more than 11-11/16 inch (297 mm).
•
Staple or punching positions are set on the upper or left-side end.
•
Be sure to load the original so that its top side is placed in the back.
•
If desired, press [Original Direction], and then select the original direction.
Settings
No. Name
1 Corner
staple
lamp
2
Center staple & fold lamp
3 [Finishing]
key
4 2-hole
lamp
5 3-hole
lamp
6 [Select
punch]
key
7 [Start/stop]
key
8 4-hole
lamp
9 Tri-fold
lamp
10
2 position staple lamp
7
6
3
5
4
2
1
8
9
10