Zebra 77660 用户手册
96
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
11.
Refer to Figure 4-33. Place the power supply heatsink clamp over the power supply
board. Install, but do not tighten, the three screws securing the power supply
heatsink clamp to the printer.
board. Install, but do not tighten, the three screws securing the power supply
heatsink clamp to the printer.
12.
Evenly snug the three screws securing the heatsink clamp.
13.
Tighten all other mounting screws and the standoff.
Figure 4-33. Install Heatsink
14.
Refer to Figure 4-29. Reinstall the connectors removed from the power supply
board. Ensure the connectors are in their proper location.
board. Ensure the connectors are in their proper location.
15.
Refer to Install Ribbon Take-Up Assembly on page 124 and reinstall the ribbon
take-up gear.
take-up gear.
16.
Reinstall the main logic board mounting bracket.
17.
Refer to Install Main Logic Board on page 87 and reinstall the main logic,
PCMCIA, and PSII boards.
PCMCIA, and PSII boards.
18.
Verify that the power switch is in the Off (
O
) position.
Heatsink
Assembly
Note • Tighten This Screw First
Mounting
Screws
Mounting
Screw
Cutaway
View
See Note