Zebra 77660 用户手册
98
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
Replace Drive Belt
Caution:
Caution • This installation must be performed by a qualified service technician.
Caution • This installation must be performed by a qualified service technician.
Caution • Turn Off (O) the printer and disconnect the printer from the power
source before performing the following maintenance.
source before performing the following maintenance.
Remove Drive Belt
1.
Turn Off (
O
) the printer and remove the AC power cord and data cables.
2.
Refer to Figure 4-35. Open the media door, remove the electronics cover mounting
screw and lock washer.
screw and lock washer.
3.
Remove the media and ribbon.
4.
Close the media door.
Figure 4-35. Locate Electronics Cover Mounting Screw
Electronics
Cover
Media
Door
Electronics
Cover
Mounting
Screw
Cover
Mounting
Screw
Lock Washer
Lower
Flange
Flange
Upper
Flange
Flange