Zebra 77660 用户手册
150
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
Figure 4-87. Install the Cutter Assembly (Z4Mplus Shown)
10.
Refer to Figure 4-87. While holding the cutter assembly, route the cutter assembly
wire harness through the opening under the platen assembly then under the main
frame.
wire harness through the opening under the platen assembly then under the main
frame.
11.
Install the cutter assembly on the hooks of the platen housing. The Z6Mplus
brackets have step slots. Hold the cutter assembly as far to the left as possible, align
the larger part of the slot with the hooks on the platen housing. Slide the cutter
assembly onto the hooks then push down and slide the assembly to the right.
the larger part of the slot with the hooks on the platen housing. Slide the cutter
assembly onto the hooks then push down and slide the assembly to the right.
12.
Secure the cutter assembly onto the platen assembly. The mounting bracket tab on
the cutter fits behind and attaches to the platen assembly leg, using the screw
provided to secure it to the platen housing assembly.
the cutter fits behind and attaches to the platen assembly leg, using the screw
provided to secure it to the platen housing assembly.
Cutter
Assembly
Mounting
Screw
Thumb
Screw
Detail A
Platen Assembly
Hooks
Cutter
Shield
Tear Bar
Tear Bar
Mounting
Screws
M
M
Detail A
Rear of Cutter
Assembly
Mounting
Bracket
Bracket
Platen
Leg
Mounting
Bracket
Main
Frame
Cutter
Harness