Zebra 77660 用户手册
152
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
Caution • Observe proper electrostatic safety precautions when handling any
static-sensitive components such as circuit boards and printheads.
static-sensitive components such as circuit boards and printheads.
15.
Refer to Figure 4-89. Feed the cutter harness under the main frame and up through
the access hole in the center of the floor of the main frame on the electronics side.
the access hole in the center of the floor of the main frame on the electronics side.
16.
Locate P26 on the main logic board and plug in the cutter assembly connector.
Route the cable as shown taking care to route it away from the drive belt and gears.
Route the cable as shown taking care to route it away from the drive belt and gears.
Figure 4-89. Cutter Option Connector Location on Main Logic Board
17.
Refer to Figure 4-85. Reinstall the electronics cover by aligning it and sliding down,
ensuring the lower flange is inside the base and the upper flange is between the main
frame and the media door.
ensuring the lower flange is inside the base and the upper flange is between the main
frame and the media door.
18.
Refer to Figure 4-84. Reopen the media door and reinstall the mounting screw and
lock washer to secure the electronics cover.
lock washer to secure the electronics cover.
19.
Reinstall the media and ribbon.
20.
Reconnect the AC Power cord and data cables.
21.
Turn On (
l
) the printer.
Cutter
Harness
Main Logic
Board Connector
(P26)
Cutter
Connector
Main
Frame
Access
Hole
Base