Zebra 77660 用户手册
24
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 2
Operations Overview
Remove Ribbon
1.
Break the ribbon between the ribbon strip plate and the ribbon take-up spindle.
2.
While turning the ribbon take-up spindle release knob counterclockwise, squeeze
the ribbon against the ribbon take-up spindle tension blades.
the ribbon against the ribbon take-up spindle tension blades.
3.
When the tension blades collapse, hold the release knob and rotate the used ribbon
toward the rear of the printer. Slide off the ribbon.
toward the rear of the printer. Slide off the ribbon.
Load Media
Tear-Off Mode
Refer to Figure 2-3
1.
Press the printhead open lever. The printhead assembly springs up.
2.
Flip down the media supply guide.
3.
Slide the media guide out as far from the printer frame as possible.
4.
Place the roll of media on the media supply hanger.
5.
Flip up the media supply guide. Slide the media supply guide in until it just touches,
but does not restrict, the edge of the roll.
but does not restrict, the edge of the roll.
6.
Feed the media under the dancer, through the slot in the transmissive sensor, under
the ribbon sensor, and out the front of the printer.
the ribbon sensor, and out the front of the printer.
7.
Ensure that the media is against the back of the transmissive sensor. Slide in the
media guide until it just touches, but does not restrict, the edge of the media.
media guide until it just touches, but does not restrict, the edge of the media.
8.
Close the printhead assembly.
Figure 2-3. Media Loading Tear-Off Mode
Printhead Open Lever
Printhead
Assembly
Media Supply Guide
Media Guide
Media
Supply
Hanger
Ribbon
Sensor
Sensor
Transmissive
Sensor