Zebra 77660 用户手册
26
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 2
Operations Overview
Peel-Off Mode
(Peel Option required.)
Refer to Figure 2-5.
1.
Press the printhead open lever. The printhead assembly springs up.
2.
Flip down the media supply guide.
3.
Slide the media guide out as far from the printer frame as possible.
4.
Place the roll of media on the media supply hanger.
5.
Flip up the media supply guide. Slide the media supply guide in until it just touches,
but does not restrict, the edge of the roll.
but does not restrict, the edge of the roll.
6.
Feed the media under the dancer, through the slot in the transmissive sensor, and
under the ribbon sensor.
under the ribbon sensor.
7.
Pull approximately 6 in. (305 mm) of media through the front of the printer.
8.
Ensure that the media is against the transmissive sensor. Slide in the media guide
until it just touches, but does not restrict, the edge of the roll.
until it just touches, but does not restrict, the edge of the roll.
9.
Pull lever to open the pivot bracket assembly.
10.
Feed the media through the slot in the peel assembly.
11.
Close the printhead assembly.
12.
Close the pivot bracket assembly.
13.
Peeling will automatically start. Press FEED to test.