Zebra 77660 用户手册
40
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 2
Operations Overview
Printer Self Tests
The printer is designed to work with most Zebra media and ribbon combinations.
However, in some applications, changes to the printer’s configuration and mechanical
settings may be required. For these situations, printer self test labels can be used to check
print quality and ensure proper operation.
However, in some applications, changes to the printer’s configuration and mechanical
settings may be required. For these situations, printer self test labels can be used to check
print quality and ensure proper operation.
These self tests produce sample printouts and provide specific information that determines
the operating conditions for the printer.
the operating conditions for the printer.
Each self test can be enabled from the LCD menu. Hold MINUS (–) and turn On (
l
) the
printer to access the menu.
Cancel Key Self Test
Press and hold CANCEL while turning On (
l
) the printer. Release the key anytime after
the first front panel LED turns off. The Cancel Key Self Test prints a configuration label
showing:
showing:
•
Printer Configuration.
•
Installed Options.
•
Software Version.
•
Copyright Notice.
Figure 2-14 shows an example of the printer configuration label. The configuration
information will print over several labels if a label is not long enough to display all of the
configuration information at one time.
information will print over several labels if a label is not long enough to display all of the
configuration information at one time.
Note •
When performing self tests, disconnect all data interface cables from the printer.
When canceling a self-test before it's actual completion, always turn Off (O) the printer
and then it On (l) to reset the printer.
When performing these self tests while in the peel mode, you must remove the labels as
they become available.
For self test, Zebra recommends using full-width media. Ensure your print width is set
correctly for the media you are using before you run any self tests; otherwise the test
may print out on the platen.
and then it On (l) to reset the printer.
When performing these self tests while in the peel mode, you must remove the labels as
they become available.
For self test, Zebra recommends using full-width media. Ensure your print width is set
correctly for the media you are using before you run any self tests; otherwise the test
may print out on the platen.