Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES 用户手册

5.   

Advanced Configuration

This chapter describes how to configure the advanced features of your ProSafe Dual Band 
Wireless-N Access Point WNDAP360. This chapter includes the following sections:

Spanning Tree Protocol and 802.1Q VLAN

The advanced General system settings screen allows you to enable the Spanning Tree 
Protocol (STP) and configure the VLANs.

STP provides network traffic optimization in locations where multiple wireless access points 
are active.

The 802.1Q VLAN protocol on the wireless access point logically separates traffic on the 
same physical network:

Untagged VLAN. When the wireless access point sends frames that are associated with 
the untagged VLAN from its Ethernet interface, those frames are untagged. When the 
wireless access point receives untagged frames over its Ethernet interface, those frames 
are assigned to the untagged VLAN.

Select the Untagged VLAN check box only if the hubs and switches 

on your LAN support the 802.1Q VLAN protocol. Likewise, change 
the untagged VLAN value only if the hubs and switches on your LAN 
support the 802.1Q VLAN protocol. Selecting the Untagged VLAN 
check box or changing the untagged VLAN value will result in a loss 
of IP connectivity if the hubs and switches on your LAN have not yet 
been configured with the corresponding VLAN.