Rigol DS1104Z 4-channel oscilloscope, Digital Storage oscilloscope, DS1104Z 用户手册
产品代码
DS1104Z
RIGOL
DS1000Z Quick Guide
7
Probe Compensation
When the probes are used for the first time, you should
compensate the probes to match the input channels of the
oscilloscope. Non-compensated or poorly compensated probes
may cause measurement inaccuracy and error. The probe
compensation procedures are as follows:
1. Perform step 1, 2, 3 and 4 of “Function Inspection”.
2. Check the displayed waveforms and compare them with the
following figures.
Figure 8 Probe Compensation
3. Use a nonmetallic driver to adjust the low-frequency
compensation adjustment hole on the probe until the
displayed waveform is as the “Correctly compensated” in the
figure above.
displayed waveform is as the “Correctly compensated” in the
figure above.
Over compensated Perfectly compensated Under compensated