MEAN WELL LPV-35-24 数据表

5V

12V

15V

24V

36V

5A

3A

2.4A

1.5A

1A

0 ~ 6A

0 ~ 3A

0 ~ 2.4A

0 ~ 1.5A

0 ~ 1A

30W

36W

36W

36W

36W

80mVp-p

120mVp-p
¡Ó5.0%

120mVp-p

150mVp-p

150mVp-p

¡Ó6.0%
¡Ó1.0%
¡Ó4.0%
500ms, 20ms / 230VAC 5

at full load

00ms, 20ms / 115VAC

90 ~ 264VAC

127 ~ 370VDC

47 ~ 63Hz

77%

84%

¡Ó2.0%

84%

85%

85%

5.75 ~ 6.75V

13.8 ~ 16.2V

17.25 ~ 20.25V

27.6 ~ 32.4V

41.4 ~ 48.6V

1.1A/115VAC

0.7A/230VAC

0.25mA / 240VAC

110 ~ 150% rated output power

Protection type : Hiccup mode, recovers automatically after fault condition is removed

Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3

Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A

-30 ~ +65

¢J (Refer to "Derating Curve")

20 ~ 90% RH non-condensing

-40 ~ +80

, 10 ~ 95% RH

¢J

¡Ó

¢J

¢J

0.03%/

(0 ~ 50

)

10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes

UL1310, CAN/CSA C22.2 No. 223-M91, IP67 approved ; design refer to TUV EN60950-1

743.5Khrs min.

MIL-HDBK-217F (25

)

¢J

148*40*30mm (L*W*H)

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25

of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the

complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.

6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
7. LPV-35-5 can provide 6A of output current continuously. Based on the requirement of UL1310 class 2, the output current is only certified up to 5A for

the test report of LPV-35-5.

8. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
9. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.

¢J

0.34Kg; 40pcs/14.6Kg/0.63CUFT

Protection type : Shut down o/p voltage, re-power on to recover

35W Single Output Switching Power Supply

¡½

Features :

50ms/230VAC

16ms/115VAC at full load

I/P-O/P:3KVAC

I/P-O/P:>100M Ohms / 500VDC / 25

/ 70% RH

¢J

Constant voltage design
Universal AC input / Full range
Withstand 300VAC surge input for 5 seconds
Protections: Short circuit / Overload / Over voltage
Cooling by free air convection
Fully encapsulated with IP67 level

Class 2 power unit

ass LPS

Suitable for LED lighting and moving sign applications
100% full load burn-in test
Low cost, high reliability
2 years warranty

¡E

¡E

¡E

¡E

¡E
¡E

¡E

¡E

¡E

¡E

¡E

¡E

¡E

¡E

¢º

(Note.9)

Fully isolated plastic case
Class

power unit, no FG

P

(Note.8)

COLD START 55A(t

=510 s measured at 50% I

) at 230VAC

width

peak

£g