CHIPDRIVE CLOUD 4700F 905511 数据表

 

 

This Escape command is used to get or set the following parameters: 

x  Smart card Power-on sequence 

x  Delay between successive Activation retires 

x  Enable/Disable any Voltage Class 

 

As soon as card insertion is detected and Power ON message is received from the host, the 
firmware will start Activation with the configured voltage sequence. If the Activation fails, it will 
wait for the configured Activation delay and then retry with the next enabled Voltage class. If 
power up succeeds at an operating voltage, the firmware will continue card communication at 
that voltage. If power up fails in all the enabled operating voltages, then the firmware will report 
an error. 

 

The first byte of the input buffer will contain the escape code. The next byte shall contain the 
function to be performed. Third byte shall contain the parameter for the function. 

 

 

Escape 
code(0x04) 

 

0x00 

Starts with Class C voltage.  
(1.8V – 3V – 5V order) 

- 

 

0x01 

Starts with Class A voltage. 
(5V – 3V – 1.8V order) 

- 

0x08 

Time delay between resets 

Delay value in milliseconds 

0x09 

Enable/Disable a Voltage 
Class 

Bit Map of all Voltage Classes  

[Bit0 – Class A; Bit1 – Class B; 
Bit2 – Class C] 

Set bit to enable the Voltage 
class 

Clear bit to disable the Voltage 
class  

0xFE 

Retrieves all the Activation 
Configuration 

- 

0xFF 

Retrieves the current Power up 
sequence 

-