Insys GPRS 5.0 Ethernet 11-02-01-03-10.018 用户手册
产品代码
11-02-01-03-10.018
INSYS GPRS 5.0 Ethernet
Functions
Dez-06
41
The parameters for GSM/GPRS can be set on this page.
WAN connection: Determination of the GPRS connection control:
WAN connection: Determination of the GPRS connection control:
Always on (default)
After each restart, the INSYS GPRS 5.0 Ethernet will auto-
matically establish a GPRS connection. This will remain per-
manently and will be re-established after an interruption.
matically establish a GPRS connection. This will remain per-
manently and will be re-established after an interruption.
Controlled via input IN1
As soon as the input IN1 is active (terminal "IN1" connected
to "GND"), the INSYS GPRS 5.0 Ethernet will establish a GPRS
connection. After the connection has been established, the
output OUT1 will switch to normally open contact. The GPRS
connection will remain as long as IN1 is active.
When the input IN1 is deactivated (terminal "IN1" open), the
existing GPRS connection is closed. The output OUT1 will
switch back to normally closed contact.
to "GND"), the INSYS GPRS 5.0 Ethernet will establish a GPRS
connection. After the connection has been established, the
output OUT1 will switch to normally open contact. The GPRS
connection will remain as long as IN1 is active.
When the input IN1 is deactivated (terminal "IN1" open), the
existing GPRS connection is closed. The output OUT1 will
switch back to normally closed contact.
Network provider
If the INSYS GPRS 5.0 Ethernet is not supposed to register at
identification number:
the standard network provider, but a network provider should
be selected manually; this can be done in two ways:
Exclusively selected network
The INSYS GPRS 5.0 Ethernet registers at the defined network
provider. If the network of this provider is not accessible, no
registration takes place.
provider. If the network of this provider is not accessible, no
registration takes place.
Preferred selected network – otherwise automatic
The INSYS GPRS 5.0 Ethernet first attempts to register at the
defined network provider. If this fails, the system switches to
automatic network selection.
defined network provider. If this fails, the system switches to
automatic network selection.
If this field is empty (default), in principle an automatic network
selection will take place.
You will find a list with the network provider identification numbers
in the Chapter Network Provider Identification Numbers.
in the Chapter Network Provider Identification Numbers.