Futaba 6J F4103 数据表

The T6J transmitter offers dual rates on the aileron, elevator and rudder channels.  The dual rates are 
assignable to switches A, B or IDL on the transmitter and are simultaneously activated by the dual rate switch 
selected.  

The amount of travel decrease for each control may be set between 0% and 140% of the values set for the 
end points (explained in End Point Adjustment on page 33).

Note: It is possible to set a dual rate value to zero, thus causing no response from that channel when the dual 
rates are activated.  If the dual rates are inadvertently set to zero, a crash could result.

Note: ! # #  !  %<*   # +   !     #   
%<*   '##  #+ ‘]]š

Prior to programming the dual rates for the aileron, elevator or rudder channels, we suggest selection of the 
switch that will be utilized to control the rate settings.

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.  An audible double beep will be heard 

and the default screen will change accordingly.

3) Press either the MODE key OR the END key to scroll through the function 

menus.  Each time one of the aforementioned keys is pressed the menu will change 
accordingly.  Continue pressing the MODE or END key until the dual rates (D/R) 
menu appears on screen. 

4) Press the SELECT key six (6) times to scroll past the channel settings to access the switch selection 

options.

5) Press the DATA INPUT lever either upward or downward until the desired switch selection appears 

onscreen.  The options are switch A or B, or the IDL (idle up) switch.

4) Next, press the SELECT key one time to proceed to adjust the dual rates.

1) Press the SELECT key to choose the desired channel (1-aileron, 2-elevator, 4- rudder [tail rotor]) and 

switch position. The channel number appears on the left side of the screen.  The switch position (up or