Futaba 6J F4103 数据表

'~ + = '++#'#

2) Observing the up/down switch position indicator, change the dual rate value for the respective channel 

using the DATA INPUT lever until the desired control throw is achieved. 

  Again, if the arrow is pointing upward, the rate is being adjusted for the up position of the switch.  

 ^## !# ! '{!|! {'|! 

for the low rate.

3) Press the SELECT key to change the switch position indicator to the opposite position.  

Note: This assumes that the modeler has adjusted the up switch position.  If the down switch position was 
adjusted, the SELECT key will move to the next channel or switch selection menu as the case may be.

4) Change the dual rate value for the respective channel using the DATA INPUT lever until the desired 

control throw is achieved. 

5) Repeat the procedure for the remaining channels and switch positions as desired.  

6) Press and hold the END button to save these settings and exit the programming menu.

Exponential, or EXPO as it is commonly abbreviated, affects the travel of the servos around their center in 
relationship to stick movement.  Exponential does NOT impact the overall travel volume of the servos.  A 
!  &!# {›|            }#~  " !  ;   
! !#  #'##+ " #! 
 # {${&!#!'##  } ~} ~# 
neutral position.  

The T6J transmitter offers exponential adjustments for the ailerons, elevator and rudder channels.  The EXPO 
settings are controlled by the switch that has been selected for the dual rates (D/R).  As with the dual rates 
settings, the exponentials are also simultaneously activated.

 

;# # + +'$‘]]š›‘]]š#  
the end points (explained in End Point Adjustment on page 

??

).

1) Turn the transmitter on.