Spektrum DX6i SPM6630 用户手册

SPEKTRUM DX6i • RADIO INSTRUCTION MANUAL

•  Transmitter batteries fully charged.
•  Bind the transmitter to the model.
•  Connect the trainer cord (SPM6805) to the back of the 

transmitter.

•  Make sure the slave transmitter batteries are fully charged.
•  Make sure the slave transmitter is powered off; the slave 

transmitter receives power when you connect the trainer 
cord. At this point, the slave will not transmit a signal to the 
model.

•  Move and hold the master transmitter’s trainer switch to 

give model control to a slave transmitter.

•  The trainer switch is on the back left of the transmitter 

(Mode 2, used in USA or on the right side on Mode 1 trans-
mitters).

•  Release the trainer switch to give model control to the 

master transmitter.

•  Make sure transmitter batteries are fully charged.
•  Make sure transmitter is powered ofF 
•  Connect the trainer cord between the master and slave 

transmitters.

•  The DX6i screen will show information, but the transmitter 

will not send a signal to the model.

•  Both transmitters must be programmed to control the 

model. 

NOTICE: You must set up a model the same in both transmitters 
before using the trainer cord. The trainer cord does not copy 
model control values from one transmitter to another. 

The Differential function decreases the amount an aileron moves 
down without affecting the amount the other aileron moves up. 
This can decrease swerving (adverse yaw) tendencies during roll 
maneuvers. 
Differential is not available in this transmitter for flying-wing 
airplanes (ELEVON option in WING TAIL MIX). 
Note: Use of the Differential function requires choosing  
DUALAILE in WING TAIL MIX function.  

A  Option value (0-100%)

DIFFERNTIAL

DUALAILE  RATE        0%

List

A

Revo Mix mixes tail rotor input and throttle/collective input to 
counteract main rotor torque. This function has UP and DN 
(down) revolution mixing for flight modes NORM and STUNT. 
Move the F MODE switch to activate a flight mode.  
Note: Use REVO MIX only for non-heading hold gyros.
Note: Move Throttle stick slowly. Ignore turning of helicopter 
nose when first moving throttle.  

Adjust for middle-to-high throttle settings:

1. Put helicopter in a stable hover with tail rotor trim (rudder) at 

center.

2. Increase throttle to start a stable climb. 
3. When helicopter nose turns, change UP setting so nose 

does NOT turn. 

Adjust for middle-to-low throttle settings:

1. At a safe height, decrease throttle so helicopter falls slowly. 
2. When helicopter nose turns, change DN setting so nose 

does NOT turn. 

A  F Mode switch position (    = active)
B  Option values (   100 to 0 to    100)
C  Direction of helicopter movement

REVO  MIX

NORM 

    STUNT

UP     0%   UP       0%

DN     0%   DN       0%

List

A

B

C