DJI Quadcopter RtF incl. GPS, incl. camera Inspire 1 with 2RC 数据表

©

 2014 DJI. All Rights Reserved. 

Remote Controllers

INSPIRE 1

  User Manual

RC Control Setting

Remote Control Calibration

Stick Mode

Gimbal Pitch/Yaw

C1

C2

Reset gimbal yaw

Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled. 

Do not change unless familiar with your new mode.

You can customize the C1 and C2 buttons on the back 

of the remote controller.

Linking Remote Controller

C2

Searching for aircraft frequency, 

timeout in 54 seconds

Cancel

Press the linking button on the aircraft 

to link this remote controller

  Remote controller cannot link to the aircraft if the remote controller is set as “Slave”. Meanwhile, 

the “Slave”remote controller cannot control the orientation of the aircraft. Reset the remote 

controller to “Master” in DJI Pilot app if you wish to link the remote controller to the aircraft.

 Remote controller will disconnect from the linked aircraft if a new remote controller is linked to 

the same aircraft.

Remote Controller Compliance Version 

The remote controller is compliant with both CE and FCC requirements. 

5.  Locate the Linking button on the front of the aircraft, as shown in the figure shown below. Press the 

Linking button to start linking. The Remote Controller Status Indicator will display solid green if Link is 

succeed. 

4.  The remote controller is ready to link. The Remote Controller Status Indicator blinks blue and "beep" 

sound is emitted.