ConiuGo 700100107 EasyGuard II 700100107 用户手册
产品代码
700100107
36
Revision 9.0
GSM Alarm & Telemetry systems
valid. So the complete event is finished. However, if the event is still active after the
maintenance time (the reason for the event persists) the number sequence is started
again. If the triggering event falls but immediately appears again, this is registred as
a new event which once more triggers the action and expects an acknowledgement.
<4e> Maintenance
The function "maintenance" does not occur before an event was acknowledged. This
is because it would make no sense that an event is reported by both an acknowl-
edgement and a call for maintenance. The function "maintenance" is not dedicated to
inform anybody but to call a well-informed person that is able to clear the situation
directly at the locality. Sending SMS for maintenance permanently reminds the per-
son for this. If the call for maintenance via SMS is active it can only be stopped if the
triggering condition (event) is not active any longer. However, the module cannot
detect whether an event was stopped by a maintenance person or due to any action
of the module (e.g. switching on a device solving the problem).
The use of the system without acknowledgement is possible
only if the time for acknowledgement and for maintenance are
set to zero.
<4f> Multi call
If the function “Multi call” is activated on an event SMS will be sent to all 4 numbers
in the telephone number list at nearly the same time. So it is possible to inform sev-
eral persons or locations at the same time (e.g. service technician, repair shop, secu-
rity service). The SMS will be sent one after the other in short sequence of a few
seconds (“quasi parallel”).
12.4 <C>onnection Settings
Here you have the option to combine possible events with actions.
The connection settings are splitted in 4 areas:
•
Outgoing SMS
•
Digital outputs
•
Voice / modem connection
•
Send systems status