Olimex Open Source Hardware ARDUINO-like development board OLIMEXINO-5510 OLIMEXINO-5510 用户手册
产品代码
OLIMEXINO-5510
OLIMEX© 2012
OLIMEXINO-5510 User's Manual
6.6.1 P_OUT/P_IN
When in position P_IN, the board gets powered by SBW debugger.
When is position P_OUT, the board gets powered by other two sources.
When is position P_OUT, the board gets powered by other two sources.
The default position is P_OUT.
6.6.2 3.3V_E
When open 3.3V_E the processor doesn't receive power. Processor pins 11 and 28 are disconnected
from the power circuit.
from the power circuit.
The default position is closed.
6.6.3 AGND_E
When open AGND_E disables the analog ground signal.
The default position is closed.
6.6.4 CHG_D
When closed disables the battery charging circuit.
The default position is jumper open.
6.6.5 AREF_E
When open disables the AREF on the Arduino CON4.
The default position is open.
6.6.6 TI_TST/OLI_TST and TI_RST/OLI_RST
Note these jumpers must be moved together!
They control the TST and RST signals on the SBW interface. The TST and RST differ when using
different programmers. If you are not sure how your programmer is configured and the board
different programmers. If you are not sure how your programmer is configured and the board
Page 20 of 29