Reely ARF 1095 mm 208918 数据表





Before you start assembly, check the parts for the scope of delivery of your model.

• Fuselage with canopy

• Left and right wings

• Wing plug-in tube

• Tail unit

• Fin

• Motor cowl

• Main landing gear, tail spur, wheel covers, wheels

• Small parts like screws and linkage parts

• Operating instructions

The following components not included in delivery are required for assembly and operation:

Soldering gun, cutter knife, screwdriver, 5-minute epoxy resin, 30-minute epoxy resin, possibly thixotropic agents
(micro-balloon or cotton flock) for thickening the resin, threadlocker varnish, super glue and sand paper.

Observe the safety information of the respective manufacturer when using glues and work with glues in well-
ventilated rooms only.

Flying requires a suitable (computer) remote control system with at least 5 channels. Furthermore, an electrical motor,
a matching flight controller, a propeller and a propeller tappet, a 3-cell LiPo-battery with a capacity of 2700 mAh
(discharge rate at least 30C), the matching high-current plugs and 4 servos of the 9 g-class with at least 20 Ncm thrust
(ideally with metal gear) are needed.

For a model like the „X-Trema 330S ARF“, we recommend use of a state-of-the-art 2.4 GHz computer
remote control system with mixing functions. In this case, you have the option of putting every servo to a
separate receiver output to thus set every servo individually.