Renkforce MP 8000 MP-8000 数据表

产品代码

MP-8000

8. Connection

The power amplifier has cinch sockets and symmetrically connected XLR inputs.
The connections selected do not affect function. Only use one connection type at a time, though.
The power amplifier has stable screw terminals for speaker connection.

Only use suitable shielded XLR or cinch cables for connection to inputs. Using other cables may

lead to interferences.

To avoid distortion or mismatches that may damage the device, the XLR inputs must only be con-
nected to sources with an XLR output and the cinch inputs only to sources with a cinch output.

Connection to the speakers must be two-wire each. Insulate any open connection points. Make
sure that the cables are not damaged by sharp edges.

Only use speakers with sufficient load capacity (see “Technical Data”).

Connect the speakers directly to the power amplifier. Do not use any headphones or junction
boxes! If in doubt, contact a specialist.

Observe that all speakers have the correct polarity - that is, that plus and minus marks match.

The power amplifier was developed for operation with speaker impedances of at least 4 Ohm.
Never connect speakers with a lower impedance.

Also observe the connection values in the chapter “Technical Data”.

a) Connection of the In- and Outputs

• Connect the outputs of your audio source (mixer, equalizer, etc.) to the corresponding inputs of the power

amplifier.

Connect the left channel to the corresponding input socket LINE IN CH1 (4 or 5). Connect the right chan-

nel to the corresponding input socket LINE IN CH2 (4 or 5).

• Connect the left speaker to the speaker output POWER OUT CH1 (6). Connect the right speaker to the

speaker output POWER OUT CH2 (6).

Connect the plus pole of the speaker to the red speaker output terminal and the minus pole of the speaker

to the black speaker output terminal.