Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 数据表
产品代码
RF1000
91
d) Use of the Software in the Quickprint Mode
(1) Click “Expert”.
(2) Select “Switch to quick print...”
(2) Select “Switch to quick print...”
The software interface is now simplified and only very few settings need to be made before printing.
This surface is ideal for producing the first test prints and familiarising yourself with the software settings and the resulting
This surface is ideal for producing the first test prints and familiarising yourself with the software settings and the resulting
changes.
In Quickprint mode, start and end G-Codes or Z-calibration are not supported. These settings are, ho-
wever available in expert mode (for more information, see the instructions and the forum under
www.ultimaker.com).
Try printing the object already on the software printing plate with different settings and inspect the different results.
Find some information on the possible settings enclosed:
Find some information on the possible settings enclosed:
(1) Selection of the printing quality (the higher, the slower the print)
(2) Selection of the filament material and filament diameter
(3) With the field activated, supporting structures are printed as well (required when printing out with overhangs, e.g. for
(2) Selection of the filament material and filament diameter
(3) With the field activated, supporting structures are printed as well (required when printing out with overhangs, e.g. for
bridges)
(4) Loading 3D files to be printed
(5) Start the printing process
(6) Selection of view options
(5) Start the printing process
(6) Selection of view options