Datalogic PowerScan PD9500 PD9530-HPK1 数据表

Enter/Exit Programming Mode

236

PowerScan™ PD9530/PBT9500/PM9500

The features in this section are valid only for the PowerScan PM9500 Star 

model:

•

•

This parameter sets the valid wait time before transmission between the 

handheld reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (num-

ber of readers in the same area). The selectable range for this feature is 

from 02 to 25 seconds. See 

 in “References” for detailed informa-

tion and examples for setting this feature.

Set Radio Protocol Timeout

To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code 
at left followed by two digits from the Alphanumeric 
characters in 

 representing 

your desired character(s). End by scanning the 
ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL barcode to abort 
and not save the entry string. You can then start again 
at the beginning.

~

CANCEL

DEFAULT