Datalogic PowerScan PD9500 PD9530-HPK1 数据表

References

306

PowerScan™ PD9530/PBT9500/PM9500

1. Link the PM9500 with a BC9xxx Base. 
2. With the PM9500, read a Compatible Mode programming label on 

 to set low, intermediate, or high speed.

3. Place the PM9500 into the BC9xxx. 

The Reader and Base will now be linked at the new programmed speed.

This feature can also be programmed using Datalogic Aladdin.

1. On the BC9xxx Base, change the Compatible mode parameter to low, 

intermediate, or high speed through Aladdin.

2. Place an unlinked PM9500 onto the BC9xxx base. 

The Reader and base will link with the new programmed speed.

This option specifies the 4-character or 16-character pin code to be used 

for authentication of the Bluetooth 

link. 

To set the pin code:

1.

Scan the 

ENTER/EXIT PROGRAMMING MODE bar code to enter Program-

ming Mode, then enable 

2.

Specify the desired pin code length (4 or 16) by scanning the appropri-

ate bar code in 

on page 226. 

3. Determine the desired characters. For example, D254 or 

STOR12345678135M.

4. Convert the characters to hexadecimal using the

on the 

inside back cover of this manual. 

5. Go to 

 and Scan the bar code: SET 4 CHAR PIN CODE or SET 

16-CHAR PIN CODE.

6. Scan the appropriate alphanumeric characters from the keypad in 

, representing the hexadecimal entries determined 

in the steps above. You will hear a two-beep indication after the last 

character.