Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037 用户手册

Adjusting the V-tail mixer:
•  Switch on the transmitter and call the function setting menu.
•  Move the cursor arrow to the menu item „V tail“ with the two

buttons „UP“ and „DOWN“.

•  Briefly push the button „OK“ to activate the menu item.
  The display shows the mixer indication with pre-set values.
•  Pushing  the  buttons  „UP“  or  „DOWN“  can  activate  „On“  or

deactivate „Off“ the mixer.

•  When pushing the button „OK“, the cursor arrow will jump to

the defection values for the elevator function (CH2). 

•  Alternatingly  deflect  the  encoder  for  the  elevator  function

down or up to the stop and adjust the desired deflection va-

lues of both servos by pushing the buttons „UP“ or „DOWN“. 

When setting a negative value, the running directions of the 

two servos will reverse. If the button „OK“ is pushed and held, 

the factory parameters are called.

•  When  pushing  the  button  „OK“  briefly  again,  the  cursor  ar-

row will jump to the deflection values for the rudder function

(CH4). 

•  Alternatingly deflect the encoder for the rudder function on the

one side to the stop and adjust the desired deflection values

of both servos by pushing the buttons „UP“ or „DOWN“. If the 

button „OK“ is pushed and held, the factory parameters are 

called.

•  Keep the button „CANCEL“ pushed for a longer period to save

the settings. The display then shows the function setup menu 

again.

•  Push the button „CANCEL“ repeatedly until you get back to

the operating display.

  If one of the two servos runs in the wrong direction, 

you can use the reverse setting (see chapter 14. a) to 

change the running direction of the servo.

 

The remote control transmitter does not permit con-

current operation of the delta and V-tail mixer. In this 

case,  the  following  error  message  will  be  displayed 

when the second mixer is called: „Elevon enabled“ or 

„V tail enabled“.