Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037 用户手册

  This menu is only available if a helicopter model was selected in the system settings menu!

So-called gyroscope (or gyro) systems are used in order to stabilise the tail of the helicopter in the air. There is a 

connection between the receiver and the tail servo. If the tail turns sideways as a result of a wind gust or other external 

influences, this is recognised by the gyro and a corresponding control command is sent to the tail servo to counter the

turn. Gyroscope systems that have an additional controller input permit setting the individual sensitivity for each flight

condition separately and independently of each other. This requires the controller input for the gyro to be connected 

to channel 5 of the receiver.
For further information, refer to the design documents of the gyro system.
Setting the gyro sensitivity:
•  Switch on the transmitter and call the function setting menu.
•  Move the cursor arrow to the menu item „Gyroscope“ with the

two buttons „UP“ and „DOWN“.

•  Briefly push the button „OK“ to activate the menu item.
  The display shows the current switching condition of the gyro 

sensitivity, the flight condition „Normal“ (the switch „SWB“ must

be in the front position for this) and the set value. The cursor 

arrow in the mixer function shows that the gyro sensitivity now 

can be activated or deactivated.

•  Pushing  the  buttons  „UP“  or  „DOWN“  can  activate  „On“  or

deactivate „Off“ gyro sensitivity.

•  When pushing the button „OK“, the cursor arrow will jump to

the setting value for gyros sensitivity. 

•  Push the buttons „UP“ or „DOWN“ to set the gyro sensitivity for

the flight condition „Normal“. If the button „OK“ is pushed and

held, the factory parameters are called.