Intel D2500 DF8064101055400 数据表
产品代码
DF8064101055400
Datasheet - Volume 1 of 2
23
2.4
PLL Signals
2.5
Analog Display Signals
Table 2-11.PLL Signals
Signal Name
Description
Direction
Type
DDR3_REFP
DDR3_REFN
DDR3_REFN
Differential DDR3 I/O Clock In
I
Diff Clk
CMOS
HPLL_REFCLK_N
HPLL_REFCLK_P
HPLL_REFCLK_P
Differential Host Clock In
I
Diff Clk
CMOS
DMI_REFCLKP
DMI_REFCLKN
DMI_REFCLKN
Differential DMI Clock In
I
Diff Clk
CMOS
DPL_REFCLKN
DPL_REFCLKP
DPL_REFCLKP
Differential PLL Clock In. 27 MHz XTAL required
to reduce error to <1000 ppm
I
Diff Clk
CMOS
DPL_REFSSCLKN
DPL_REFSSCLKP
DPL_REFSSCLKP
Differential Spread Spectrum Clock In
I
Diff Clk
CMOS
Table 2-12.Analog Display Signals (Sheet 1 of 2)
Signal Name
Description
Direction
Type
CRT_RED
RED Analog Video Output: this signal is a CRT analog video signal
output from the internal color palette DAC. The DAC is designed to
drive a double terminated 75 Ohm DC resistance without the need
for external buffering. A dual 150 Ohm termination scheme is
implemented on the board for optimal signal integrity: one 150
Ohm termination to ground placed in close proximity to the chip and
one 150 Ohm termination resistor to ground placed in close
proximity to the VGA connector. The equivalent DC resistance of the
two 150 Ohm termination resistors with the 75 Ohm termination
within the CRT display is 37.5 Ohms (DC).
O
Analog
CRT_GREEN
GREEN Analog Video Output: this signal is a CRT analog video signal
output from the internal color palette DAC. The DAC is designed to
drive a double terminated 75 Ohm DC resistance without the need
for external buffering. A dual 150 Ohm termination scheme is
implemented on the board for optimal signal integrity: one 150
Ohm termination to ground placed in close proximity to the chip and
one 150 Ohm termination resistor to ground placed in close
proximity to the VGA connector. The equivalent DC resistance of the
two 150 Ohm termination resistors with the 75 Ohm termination
within the CRT display is 37.5 Ohms (DC).
O
Analog
CRT_BLUE
BLUE Analog Video Output: this signal is a CRT analog video signal
output from the internal color palette DAC. The DAC is designed to
drive a double terminated 75 Ohm DC resistance without the need
for external buffering. A dual 150 Ohm termination scheme is
implemented on the board for optimal signal integrity: one 150
Ohm termination to ground placed in close proximity to the chip and
one 150 Ohm termination resistor to ground placed in close
proximity to the VGA connector. The equivalent DC resistance of the
two 150 Ohm termination resistors with the 75 Ohm termination
within the CRT display is 37.5 Ohms (DC).
O
Analog