Whirlpool WED9151YW 用户手册

To avoid damaging floor, use a large flat piece of cardboard 

from dryer carton; place under entire back edge of dryer. 

Firmly grasp dryer body (not console panel) and gently lay 

dryer down on cardboard.

4-wire 

receptacle 

(14-30R)

Then choose a 4-wire power supply cord with 

ring or spade terminals and UL listed strain 

relief. The 4-wire power supply cord, at least  

4 ft. (1.22 m) long, must have 4 10-gauge solid 

copper wires and match a 4-wire receptacle of 

NEMA Type 14-30 R. The ground wire (ground 

conductor) may be either green or bare. The 

neutral conductor must be identified by a  

white cover.

3-wire 

receptacle 

(10-30R)

Then choose a 3-wire power supply cord with 

ring or spade terminals and UL listed strain 

relief. The 3-wire power supply cord, at least  

4 ft. (1.22 m) long, must have 3 10-gauge solid 

copper wires and match a 3-wire receptacle of 

NEMA Type 10-30R.

diamond

marking

Examine leveling legs, find diamond marking. Screw legs into  

leg holes by hand—use a wrench to finish turning legs until 

diamond marking is no longer visible.

Now stand the dryer on its feet. Slide the dryer until it is 

close to its final location. Leave enough room for electrical 

connection and to connect the exhaust vent.

Power supply cable must match power supply (4-wire or 3-wire) 

and be:

 

■

Flexible armored cable or nonmetallic sheathed copper cable 

(with ground wire), covered with flexible metallic conduit.  

All current-carrying wires must be insulated.

 

■

10-gauge solid copper wire (do not use aluminum) at least  

5 ft. (1.52 m) long.