Southbend SB1023 用户手册

For Machines Mfg. Since 8/09

Model SB1023

-15-

Once your machine is set up and assembled as 

previously described in this manual, it is ready to 

be connected to the power source.

Note About Extension Cords: Using an 

incorrectly sized extension cord may decrease the 

life of electrical components on your machine.

Required Power Source ........ 110V, 1-Phase, 60Hz

Full Load Amp Draw .............................. 9.5 Amps

Phase ..........................................................1-Phase

Frequency ...................................................... 60 Hz

Minimum Circuit Size ............................. 15 Amps

Included Plug ...................................... NEMA 5-15

Minimum Extension Cord Size ................ 14 AWG

Maximum Extension Cord Length ................ 50 ft.

Required Power Source ........ 220V, 1-Phase, 60Hz

Full Load Amp Draw ................................. 5 Amps

Phase ..........................................................1-Phase

Frequency ...................................................... 60 Hz

Minimum Circuit Size ............................. 15 Amps

Recommended Plug/Receptacle .......... NEMA 6-15

Minimum Extension Cord Size ................ 16 AWG

Maximum Extension Cord Length ................ 50 ft.

Wiring diagrams are provided in the back of 

this manual (Page 36) showing the Model 

SB1023 wired for both 110V and 220V. 

Refer to these diagrams when following this 

procedure. Additionally, you must purchase the 

220V conversion kit in order to complete the 

conversion. Call our parts department at 

1.  DISCONNECT MACHINE FROM POWER!

2.  Rewire the motor for 220V, as shown in the 

diagram on the inside of the motor junction 

box. If there is not a diagram in the junction 

box, use the diagram in this manual (Page 

36).

3.  Replace the contactor on the machine with 

the contactor from the 220V conversion kit. 

Set the amp dial to 5.5A

4.  Replace the power cord plug with a NEMA 

6-15 plug.