Southbend SB1023 用户手册

-16-

For Machines Mfg. Since 8/09

Model SB1023

After all preparation steps have been completed, 

the machine and its safety features must be 

tested to ensure correct operation. If you discover 

a problem with the operation of the machine or 

its safety components, do not operate it further 

until you have resolved the problem.

Refer to Troubleshooting on Page 34 for 

solutions to common problems that may occur 

with surface grinders. If you need additional 

help, contact our Technical Support at 

(360) 734-1540.

1.  Read and follow the safety instructions 

at the beginning of the manual, take the 

required safety precautions, and make sure 

the machine is set up and adjusted properly. 

2.  Ring test the grinding wheel, and install the 

wheel onto the spindle. 

 

Refer to Ring Test on Page 25, and 

Installing & Removing Grinding Wheels 

on Page 20 for procedures.

3.  Clear away all tools and objects used during 

assembly and preparation.

4.  Connect the machine to the power source.

5.  Push the STOP button in, then twist it 

clockwise so it pops out. When the STOP 

button pops out, the switch is reset and 

ready for operation.

6.  Verify that the machine is operating 

correctly by pushing the START button.

•  When operating correctly, the machine 

runs smoothly with little or no vibration 

or rubbing noises.

Your machine was lubricated at the factory, 

but we strongly recommend that you inspect all 

lubrication points yourself and provide additional 

lubrication if necessary. Refer to Lubrication on 

Page 30 for specific locations.

•  Investigate and correct strange or 

unusual noises or vibrations before 

operating the machine further. Always 

stop the machine and disconnect it from 

power before investigating or correcting 

potential problems.

7.  Press the STOP button.

8.  WITHOUT resetting the switch, press the 

START button. The machine should not 

start.

•  If the machine does not start, the 

STOP button safety feature is working 

correctly.

•  If the machine does start (with the 

stop button pushed in), immediately 

disconnect power to the machine. The 

STOP button safety feature is not 

working correctly. This safety feature 

must work properly before proceeding 

with regular operations. Call Tech 

Support for help.

The following list of adjustments were performed 
at the factory before your machine was shipped:

•  Ring Test on Page 25

•  Wheel Dressing on Page 25

•  Wheel Balancing on Page 26

•  Lubrication on Page 30

•  Handwheel Backlash Adjustment on 

•  Column & Table Gib Adjustment on