Roland BR-600 用户手册
15
Introduction to the BR-600
Re
v0.10
v0.10
The BR-600 uses CompactFlash cards as the storage media
for recording and playback.
for recording and playback.
The BR-600 uses 32 MB to 1 GB CompactFlash cards with a
3.3 V power supply.
3.3 V power supply.
For more on supported memory cards (CompactFlash) for
the BR-600, refer to “About Memory Cards” (separate
sheet).
the BR-600, refer to “About Memory Cards” (separate
sheet).
CompactFlash cards bought at a computer shop, or ones
previously used with a digital camera cannot be used as is
with the BR-600.
previously used with a digital camera cannot be used as is
with the BR-600.
These CompactFlash cards must first be initialized for use
with the BR-600.
For more details regarding initializing, see p. 199.
with the BR-600.
For more details regarding initializing, see p. 199.
To prevent theft of the memory card (CompactFlash), the
BR-600 is shipped from the factory with a card cover.
BR-600 is shipped from the factory with a card cover.
To remove the card cover, use the following procedure.
1
Turn over the BR-600.
2
Use a Phillips head screwdriver to remove the screws
on the bottom panel.
fig.00-020
3
Grasp the top and bottom of the card cover with your
fingers and pull the cover off in the direction
indicated in the figure.
fingers and pull the cover off in the direction
indicated in the figure.
fig.00-030
4
Attach the previously removed screws in the
positions shown in the figure to prevent loss.
positions shown in the figure to prevent loss.
5
Turn the BR-600 over, so it’s in its normal position.
Memory Cards Supported
by Your BR-600
by Your BR-600
■
Formatting the memory card
(CompactFlash)
(CompactFlash)
■
How to remove the card
cover
cover
• CompactFlash Type II cards are not compatible.
• CompactFlash cards are available at your nearest
• CompactFlash cards are available at your nearest
computer or digital camera shop.
• When turning the unit upside-down, get a bunch
of newspapers or magazines, and place them
under the four corners or at both ends to prevent
damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or
controls get damaged.
under the four corners or at both ends to prevent
damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or
controls get damaged.
• When turning the unit upside-down, handle with
care to avoid dropping it, or allowing it to fall or
tip over.
tip over.
• Should you remove the screws, make sure to put
them in a safe place out of children’s reach, so
there is no chance of them being swallowed
accidentally.
there is no chance of them being swallowed
accidentally.
• CompactFlash and
are trademarks of
SanDisk Corporation and licensed by
CompactFlash association.
CompactFlash association.
• BOSS Corporation is an authorized licensee of the
CompactFlash™ and CF logo (
) trademarks.
BR600_e2 15 ページ ２００６年４月１７日 月曜日 午前９時３分